Sv8100 Netlink - NEC Univerge SV8100 Features And Specifications Manual

Hide thumbs Also See for Univerge SV8100:
Table of Contents

Advertisement

UNIVERGE SV8100
Enhancements
This feature added with Version 1100 (1.12 or higher).
With Version 4000 software, the failover process in a Netlink environment is improved. When
network communication is down, an alarm is sent to the Attendant terminal informing of the
communication error on the network. Improvements also allow for a defined number of network
outages per clock hour before failing over.
With Version 4000 software, DT700 terminals connected via NAPT can be registered to either the
primary or a secondary system in a NetLink environment.
With Version 5000 software, NetLink Multi-SIP carrier has been added.
With Version 7000 or higher software, the SV8100 can recognize each system where the DT700 extension(s)
are connected and provide an
NetLink.
Description
The NetLink feature allows up to 16 sites to be linked together over a Data Communication IP NetLink
that allows Remote Sites to have the same service features as the Main Site, acting as one system.
Systems can be installed separately in the same building or in remote offices connected via a qualified
IP network.
With NetLink, the maximum system capacity still applies (200 Trunks and 512 Stations), but the ports
can be distributed between sites using an SV8100 CHS2U-US chassis at each location.
Each site must have a PZ-(X)IPLA/IPLB daughter board and a PZ-ME50-US Memory Expansion
Daughter Board installed on its CD-CP00-US blade. The CD-CP00-US blade at each Remote Site must
have the same data as the Main Site CD-CP00-US blade. The Main Site automatically uploads the
system data to the Remote Sites anytime it changes.
The Main Site requires a proper LK-SYS-NETLINKX-LIC license for each Remote Site.
When a communication failure occurs between the Main Site and any Remote Site, the Main Site
CD-CP00-US blade automatically changes to survival mode and operates as a stand-alone system. If
multiple Remote Sites are installed, a Remote Site can be assigned as a temporary Main Site to control
remaining connected sites.

SV8100 NetLink

Automatic Route Selection
SV8100 NetLink
COS based on the System (System ID) when using
Issue 11.0
2 - 1449

Advertisement

Table of Contents
loading

Table of Contents