NEC Univerge SV8100 Features And Specifications Manual page 837

UNIVERGE SV8100
Duplex mode (Auto, Full, or Half) and speed (10 or 100 mbps) are configured via SV8100 chassis

programming.
 The IPLB does not support half duplex, it only supports full duplex.
UNIVERGE SV8100 supports a 100 rel option and Session Timer option.

UNIVERGE SV8100 supports Early Media.

UNIVERGE SV8100 SIP restricts an outgoing call under the following conditions:

SIP configuration failed

SIP registration failed

CD-CP00-US Link down

PZ-( )IPLA/IPLB
Lack of

Both the signaling and voice ports can be configured in the SV8100. This change only affects the

packets from the SV8100 to the IP Phone. A change must be made in the IP phone to affect the
packets from the IP Phone to the SV8100.
ToS Support.

Conditions
Documentation for Polycom devices are available at

voicedocumentation.
By default Polycom devices use

string without a configuration change to the Polycom device. For example, dialing the
default Park access code
after the
changed to not include a
the Polycom SIP Configuration Local Settings.
SIP Stations which support RFC 3842 (Message Waiting) receive Message Waiting Lamp

indications.
SIP Station – PZ-32IPLA/IPLB, PZ-64IPLA/IPLB or PZ-128IPLA/IPLB does not support

NAT traversal.
SIP Station – PZ-32IPLA/IPLB, PZ-64IPLA/IPLB or PZ-128IPLA/IPLB does not support a

Blind Transfer feature.
With Version 4000 (4.01 or higher) software, video codecs H.264, H.263, and H.261 are

supported.
Video is supported when P2P for standard SIP is turned on. (Program 10-26-03 SIP Peer to

Peer Mode ON)
Auto start video when call is answered is not supported.

Standard SIP video Codecs are not supported across CCIS.

IP Single Line Telephone (SIP)
resource
6 will not work from a Polycom device because it starts dialing
#
, ignoring everything after. In this case, either the Park access code must be
#
, or the Remove End-Of-Dial Marker option must be disabled in
#
http://www.polycom.com/
to initiate dialing. Therefore,
#
Issue 11.0
cannot be used in a dial
#
2 - 805