NEC Univerge SV8100 Features And Specifications Manual page 1223

UNIVERGE SV8100
These caution statements do not apply to Version 2.0 or higher software.



PCPro converts an Electra Elite IPK II PCPro database file into a SV8100 PCPro database

file. PCPro Software Version 3.00 or higher is required.
The system data to be converted is limited to the system data listed below.
PC Programming
Failure to properly install and program ports higher than 64 (as
described below) can corrupt the SV8100 database.
If the PZ-ME50-US is not physically installed on the CD-CP00-US, do
not attempt to change the PCPro database configuration to indicate that
the PZ-ME50-US is installed on the CD-CP00-US, program ports 64 and
higher and then upload the PCPro configuration to the SV8100 system.
This process can corrupt the SV8100 database. Refer to the next bullet for
the proper installation/programming procedure.
To properly install and configure the PZ-ME50-US; first install the
PZ-ME50-US on the CD-CP00-US. Next, you must reload the system
software. With the PZ-ME50-US installed, a portion of the main software
is loaded onto the PZ-ME50-US.
Before attempting to program the ports above 64 using PCPro, a new
download must be performed after the PZ-ME50-US is installed.
PRG No.
10-23 IP System Interconnection Setup
11-01 System Numbering
11-02 Extension Numbering
13-04 Abbreviated Dial Number and Name
14-01 Trunk Basic Data Setup
14-02 Analogue Trunk Data Setup
14-05 Trunk Group
14-06 Trunk Group Routing
15-01 Extension Basic Data Setup
15-07 Programmable Function Key
21-02 Trunk Group Routing for Extensions
22-02 Incoming Service Type Setup
22-04 Incoming Ring Group Setup
22-05 IRG Assignment for Normal Ring Trunk
Name
Issue 11.0
2 - 1191