NEC Univerge SV8100 Features And Specifications Manual page 985

UNIVERGE SV8100
Guide to Feature Programming
The Level 1, Level 2 and Level 3 columns indicate the programs that are assigned when programming
this feature in the order they are most commonly used. These levels are used with PCPro and WebPro
wizards for feature programming.
Level 1 – these are the most commonly assigned programs for this feature.

Level 2 – these are the next most commonly assigned programs for this feature.

Level 3 – these programs are not often assigned and require an expert level working knowledge of

the system to be properly assigned.
Program
Program Name
Number
11-12-12 Service Code Setup (for Service
Access) – Last Number Dial
11-12-17 Service Code Setup (for Service
Access) – Clear Last Number
Dialing Data
15-02-13 Multiline Telephone Basic Data
Setup – Redial List Mode
20-08-05 Class of Service Options
(Outgoing Call Service) – Dial
Number Preview (Preset Dial)
Operation
To redial your last call:
1. Without lifting the handset, press Redial.
The last dialed number is displayed.

Last Number Redial
Description/Comments
#
Assign a service code ( 5) to use
Last Number Dial.
Assign a service code (776) to
clear the Last Number Dial.
Select the type of numbers that
are stored in the Redial List –
Internal and External numbers (0)
or External only (1).
Turn Off or On an extension user
ability to use Dial Number Preview.
This program also turns Off or On
the Last Number Redial function.
Assigned Data
1
MLT, SLT
#
(default = 5)
MLT, SLT
(default = 776)
0 = ICM/Trunk
(Extension/Trunk
Mode)
1 = Trunk Mode
(default = 1)
0 = Off
1 = On
(default = 1 for
COS 1~15)
Issue 11.0
Level
2 3




2 - 953