NEC Univerge SV8100 Features And Specifications Manual page 1331

UNIVERGE SV8100
Program
Program Name
Number
20-46-08 Security Sensor Setup – Repeat
Dial Times
20-46-09 Security Sensor Setup – Auto
Dial Calling Time
20-46-10 Security Sensor Setup –
Monitored Terminal
20-46-11 Security Sensor Setup – Interval
of Auto Dial
20-46-12 Security Sensor Setup – General
Purpose Relay Contact Detector
Circuit Setup
20-47-01 Time Pattern Setting for Watch
Mode – Watch Mode
20-48-01 Time Pattern for Security Sensor
– Security Sensor
20-55-01 Delay Timer for Security Sensor
– Sensor Delay Timer
35-02-22 SMDR Output Options – Security
Auto Dialing
Security
Description/Comments
Define repeat numbers for making
emergency call.
Define calling continue time when
making emergency call.
Define extension number for
monitor from outside. IP terminal
cannot set as monitored
extension.
Assign interval between Auto Dial
when making emergency call.
Define general purpose relay
contact detector circuit number
(programmed in Program 10-41)
for connect security sensor.
Define watch mode on/off against
time pattern 1-8.
Define security sensor on/off
against time pattern 1-8.
Assign the delay time, when the
contact detection start to work
after set the security sensor. The
sensor starts at once in case of set
0.
Select whether the system should
display the SAD (Security Auto
Dialing) on SMDR report.
Assigned Data
1
Security Sensor No.
1-8

0 = No Redial
1-255 (times)
(default = 0)
Security Sensor No.
1-8

0 = No Call
1-3600 (seconds)
(default = 120)
Security Sensor No.
1-8

Extension Number (Up
to 8 digits)
(default not assigned)
Security Sensor No.
1-8

0 = No Call
1-3600 (seconds)
(default = 0)
Security Sensor No.
1-8
0 = Not Used

1-8 = Detect Circuit
Number
(default = 0)
Time Pattern 1-8:
0 =Off
1 = On
(default = 0)
Time Pattern 1-8:
0 =Off
1 = On
(default = 0)
0-3600 (seconds)
(default = 60)
SMDR Port 1-8:
0 = No Output
1 = Output
(default = 0)
Issue 11.0
Level
2 3




2 - 1299