NEC Univerge SV8100 Features And Specifications Manual page 891

UNIVERGE SV8100
Program
Program Name
Number
10-23-01 SIP System Interconnection
Setup – System Interconnection
10-23-02 SIP System Interconnection
Setup – IP Address
10-23-04 SIP System Interconnection
Setup – Dial Number
10-40-01 IP Trunk Availability – IP Trunk
Availability
10-40-02 IP Trunk Availability – Number of
Ports
14-02-01 Analog Trunk Data Setup –
Signaling Type (DP/DTMF)
14-05-01 Trunk Group – Trunk Group
Number
14-06-01 Trunk Group Routing – Priority
Order Number
20-08-13 Class of Service Options
(Outgoing Call Service) – ISDN
CLIP
IP Trunk – H.323
Description/Comments
Determine if the system is
interconnected to another system.
Define the IP Address for the SIS
System Interconnection.
Define the Dial Number for the SIP
System.
Enable/Disable IP Trunks.
Define the number of IP Trunks
when enabled.
Set the outgoing signaling type for
the tie trunk.
Assign trunks to trunk groups then
go to Program 14-06-01 below to
set up Trunk Group Routing.
Set the priority order number 1~4.
Determine if the ISDN calling line
identity presentation and
screening indicators should be
allowed.
Assigned Data
1
0 = No (Disable)

1 = Yes (Enable)
(default = 0)
0.0.0.0~
126.255.255.254
128.0.0.1~

191.255.255.254
192.0.0.1~
223.255.255.254
(default = 0.0.0.0)
Up to 12 digits (0~9)

(default not assigned)
0 = Disable

1 = Enable
(default = 0)
0~128

(default = 0)
0=Dial Pulse (10 PPS)
1=Dial Pulse (20 PPS)
2=DTMF
(default = 2)
Trunks 1~200
Trunk Port 1~200,

Group 1,
Priority 1~200
0 = Not Specify
1~100 : (Trunk Group
Number)
1001~1100 : (1000 +
Route Table Number)
Default:
Route 1, Order

Number 1 = 1 (Trunk
Group 1)
Order Numbers 2, 3, 4
= 0 (Not Specified)
All Other Routes
(2~100) and Order
Numbers (1~4) = 0
(Not Specified)
0 = Off
1 = On

(default = 0)
Issue 11.0
Level
2 3

2 - 859