NEC Univerge SV8100 Features And Specifications Manual page 1272

Issue 11.0
Up to two versions of firmware are kept on the USB drive. One version is the current

version that the CD-CP00-US used to boot up from. The other version is the new version
that is used on the next boot up. If the boot up fails when switching to the new version, the
CD-CP00-US can revert back to the old version.
The CD-CP00-US boots from its Flash Memory if no USB drive is installed.

The time entered on the Firmware Upgrade screens is relative to the time on the

CD-CP00-US, not the PC that PCPro was launched from. The user should take into
account time zone differences when using this feature.
The time to upload a firmware package file is directly related to the file size. Generally, it

takes a few minutes.
Remote Upgrade is supported only via LAN connection. A modem or serial connection is

not supported for Remote Upgrade.
For Version 6000 or higher, USB is not needed if the system has MEMDB. You do still

need to obtain a new version of the main system software release from NEC.
Default Setting
At default, PCPro is set to Update Immediately after the upload.
System Availability
Terminals
None
Required Component(s)
PCPro
Related Features
PC Programming
Guide to Feature Programming
Refer to PC Programming on page
2 - 1240
2-1183.
UNIVERGE SV8100
Remote (System) Upgrade