Netlink Multi-Sip Carrier - NEC Univerge SV8100 Features And Specifications Manual

Hide thumbs Also See for Univerge SV8100:

Table of Contents

Restrictions

All IP Trunks must be connected to the Primary System, Version 4000 (V4.01 or lower).

The number of total ports depends on the Primary System.

System ID (Program 51-01-02) must be unique for each system in a NetLink network.

ACD/MIS can connect to the Primary (Main) site only.

Only one Voice Mail can be installed in a NetLink network.

In-Mail and VRS use the VMDB of the Primary (Main) site.

APSU can be installed in the Secondary (Remote) System, however the NetLink time zone

follows the Primary (Main) System.

Secondary systems must follow the primary CPU software settings for Mu-law/A-law within

the country where the primary system is located. SV8100 NetLink connections are only

supported within the same countries/areas. For example, the SV8100 can be connected via

NetLink between the US and Canada, however the SV8100 can not be connected via

NetLink with systems in other countries (e.g., Mexico or the U.K.).

Synchronous Ringing via NetLink is not supported.

NetLink Multi-SIP Carrier

The Version 5000 enhancement enables multiple SIP Trunk carriers to be utilized when NetLink is

The operation of SIP Trunk is described as follows when an existing Version 4000 (V4.01 or lower)

NetLink system is configured (refer to

the secondary system calls for using a SIP Trunk a total of three DSPs are required. One DSP from the

secondary and two DSPs from the Primary system. Also, only 32 Register ID's are available which are

programmed in the Primary system.

Figure 2-42 Example – Version 4000 or Earlier on page

UNIVERGE SV8100

SV8100 NetLink

Table of Contents