NEC Univerge SV8100 Features And Specifications Manual page 922

Issue 11.0
Guide to Feature Programming
The Level 1, Level 2 and Level 3 columns indicate the programs that are assigned when programming
this feature in the order they are most commonly used. These levels are used with PCPro and WebPro
wizards for feature programming.
Level 1 – these are the most commonly assigned programs for this feature.

Level 2 – these are the next most commonly assigned programs for this feature.

Level 3 – these programs are not often assigned and require an expert level working knowledge of

the system to be properly assigned.
ISDN – BRI Installation:
Program
Program Name
Number
10-03-01 ETU Setup (BRIA PKG) – ISDN
Line Mode
10-03-03 ETU Setup (BRIA PKG Setup) –
Connection Type
10-03-04 ETU Setup (BRIA PKG Setup) –
Layer 3 Timer Type
10-03-08 ETU Setup (BRIA PKG Setup) –
Dial Sending Mode
10-03-09 ETU Setup (BRIA PKG Setup) –
Dial Information Element
2 - 890
Description/Comments
Set up and confirm the Basic
Configuration data for each
CD-2BRIA. Use this program to
select the ISDN Line Mode.
Set up and confirm the Basic
Configuration data for each
CD-2BRIA. Confirm the
connection type for each
CD-2BRIA.
Set up and confirm the Basic
Configuration data for each
CD-PRTA. This program selects
the Layer 3 timer type (1~5). Each
timer value of Layer 3 is set up for
each type in Program 81-06
(T-Bus).
Select ISDN protocol.
Select ISDN Protocol if Overlap
Sending is selected in Program
10-03-08.
UNIVERGE SV8100
Assigned Data
1
0 = Not Used
1 = T-Point

(default = 1)
0 = Point-to-Multipoint
1 = Point-to-Point

(default = 0)
1~5
(default = 1)

0 = Enblock Sending

1 = Overlap Sending
(default = 1)
0 = Keypad Facility
1 = Called Party

Number
(default = 0)
ISDN Compatibility
Level
2 3