NEC Univerge SV8100 Features And Specifications Manual page 875

UNIVERGE SV8100
Program
Program Name
Number
84-06-02 PVA Data Setting – RTCP Port
Number
84-06-04 PVA Data Setting – Fract Lost
Threshold
84-06-05 PVA Data Setting – Packets Lost
Threshold
84-06-07 PVA Data Setting – Jitter
Threshold
84-06-09 PVA Data Setting – Delay LSR
Threshold
84-06-16 VoIP Info – IMCP Redirect
84-10-01 ToS Setup – ToS Mode
84-10-02 ToS Setup – Priority, IP
Precedence
84-10-03 ToS Setup – Low Delay
84-10-04 ToS Setup – Wideband
(Throughout)
IP Trunk – (SIP) Session Initiation Protocol
Description/Comments
Define the Media Gateway
Starting RTCP Port Number . The
RTCP Port Number must be the
(RTP port number + 1).
Define the fractional lost threshold
– this data will be sent to the
UNIVERGE SV8100 CD-CP00-US
when the value exceeds the
defined value.
Define the packet lost threshold –
this data will be sent to the
UNIVERGE SV8100 CD-CP00-US
when the value exceeds the
defined value.
Define the Jitter Threshold – this
data is sent to the UNIVERGE
SV8100 CD-CP00-US when the
value exceeds the defined value.
Define the Delay threshold – this
data will be sent to the UNIVERGE
SV8100 CD-CP00-US when the
value exceeds the defined value.
Set whether or not IPLA/IPLB
daughter board supports sending
the Internet Message Control
Protocol (IMCP) redirect message.
When Input Data is set to 1,
Protocol 7 is invalid. When Data is
set to 2, Protocols 2~6 are invalid.
1 = Router queuing priority.
1 = Optimize for low delay routing.
1 = Optimize for high bandwidth
routing.
Assigned Data
1
RTP Port Number + 1
(default = 10021)
0~100%
(default = 0)
0~16777215
(default = 0)
0~4294967295
(seconds)
(default = 0)
0~4294967295
(seconds)
(default = 0)
0=No
1=Yes
(default = 0)
0 = Disable (Invalid)
1 = IP Precedence

2 = Diffserv
(default = 0)
0~7
0 = Low

7 = High
(default = 0)
0~1
0 = Normal Delay, Low

Delay
(default = 0)
0~1
0 = Normal Throughput

1 = High Throughput
(default = 0)
Issue 11.0
Level
2 3






2 - 843