NEC Univerge SV8100 Features And Specifications Manual page 874

Issue 11.0
Program
Program Name
Number
22-02-01 Incoming Call Trunk Setup
44-02-01 Dial Analysis Table for ARS/F-
Route Access – Dial
44-02-02 Dial Analysis Table for ARS/F-
Route Access – Service Type
44-02-03 Dial Analysis Table for ARS/F-
Route Access – Additional Data
44-05-01 ARS/F-Route Table – Trunk
Group Number
44-05-09 ARS/F-Route Table – Maximum
Digit
84-06-01 PVA Data Setting – RTP Port
Number
2 - 842
Description/Comments
Assign the incoming trunk type for
each trunk.
Set the Dial digits for the
Pre-Transaction Table for
selecting ARS/F-Route (eight
#
digits max: 1~9, 0  , @). To
enter a wild card/don't care digit,
press Line Key 1 to enter an @.
Set the Service Type (0~3) for the
Pre-Transaction Table for
selecting ARS/F-Route.
If a Service Type is selected in
Program 44-02-02, set the
additional data, if required, for the
Pre-Transaction Table for
selecting ARS/F-Route (24 digits
#
max: 1~9, 0  , @). To enter a
wild card/don't care digit, press
Line Key 1 to enter an @.
Assign the trunk group to be used
by the ARS/F-Route Table.
Input the maximum number of
digits to send when using the
F-Route.
Define the Media Gateway starting
RTP Port Number.
IP Trunk – (SIP) Session Initiation Protocol
UNIVERGE SV8100
Assigned Data
1
Trunks 1~200
0 = Normal
1 = VRS (second
dial tone if no
VRS installed)
2 = DISA
3 = DID

4 = DIL
5 = E&M Tie line
6 = Delayed VRS
7 = ANI/DNIS
8 = DID(DDI) Mode
Switching
(default = 0)
Up to eight digits
(Use line key 1 for a
'Don't Care' digit, @)
(default not assigned)
0 = No Setting (None)
1 = Extension Call
(Own)
2 = ARS/F-Route Table
(F-Route)
3 = Dial Extension
Analyze Table (Option)
(default = 0)
1 = Delete Digit =
0~255 (255 : Delete All
Digits)
2 = 0~500
(0 = No Setting)
3 = Dial Extension
Analyze Table Number
= 0~4
(0 = No Setting)
(default = 0)
0~100, 255
0 = No Setting
255 = Extension Call
(default = 0)
0~24
(default = 0)
0~65535
(default = 10020)
Level
2 3





