NEC Univerge SV8100 Features And Specifications Manual page 803

UNIVERGE SV8100
IP Multiline Stations must register with the IP address of the IPLA/IPLB. The IP Multiline

stations registering via a URL is not supported.
If an internal paging group has only IP Multiline Stations, mutlicast is used for the page. IP

multiline terminals must have a gateway programmed to accomplish a multicast
transmission. When an actual gateway device does not exist on the network, a dummy
gateway address on the same subnet must be defined. If the paging group has any TDM
stations or an external speaker, multicast is not used and the gateway is not required.
The system sees terminal types 1 (Economy), 2 (Value), 3 (Desi-Less), 4 (Sophisticated)

and 5 (Softphone) as the same terminal type.
When using Multiple Logon, the same Personal ID index can be assigned to an

ITL/Softphone, a CTI (Desktop), and an MH240 terminal type.
Two ports of the same terminal type (Program 15-05-26) cannot be assigned to the same

Personal ID index (Program 15-05-27).
Program 10-46-01 must be set to 1 (Auto) or 2 (Manual) for Multiple Logon to work.

When three ports are assigned the same Personal ID index in Program 15-05-27, if

Program 15-05-26 is not set for those ports, the terminal types will be assigned based on
order of login. If Program 15-05-26 is set, the login order does not matter and they will
assign the correct port.
The Override feature functions the same as single login.

With Version 4000 or higher software, DT700 terminals and wireless IP terminals utilizing

NAPT can be registered to the primary or a secondary system. Refer to the feature
SV8100 NetLink on page 2-1449
With SV8100 Version 5000 (5.00 or higher) software and PZ-IPLB daughter board

installed, half duplex connections are not supported. For troubleshooting purposes, a
managed switch capable of port mirroring is required to capture packet data from the
SV8100 IPLB Ethernet port.
When upgrading to Version 3100 or higher software, four IP Terminal Basic licenses are

provided. If a system with Version 3000 (3.01 or lower) is upgraded to Version 3100
software, the system gains four IP Terminal licenses as soon as it is upgraded.
When downloading firmware for DT700 and the ITL-12CG/ITL-12DG terminals, the

following apply:
Version 7000 software – if you have both ITL-12CG/ITL-12DG and previously installed

DT700 series terminals, firmware updates must be downloaded separately.
Version 8000 software – firmware for both (previously installed DT700 and ITL-12CG/ITL-

12DG terminals) can be downloaded at the same time.
IP Multiline Station (SIP)
for additional details.
Issue 11.0
2 - 771