NEC Univerge SV8100 Features And Specifications Manual page 827

UNIVERGE SV8100
Feature Name
Virtual Extension
VM8000 InMail
Voice Mail Integration (Analog)
Voice Over
Voice Over Internet Protocol (VoIP)
Voice Response System (VRS) – Call
Volume Controls
Conditions
The maximum number of ML440 Handsets that can register to one AP20 Access Point is

30.
The maximum number of ML440 Handsets supported in one SV8100 system is 200.

The maximum number of AP20 Access Points supported on one SV8100 is 40.

In a multi-cell system each AP20 supports a maximum of eight simultaneous voice paths.

The ML440 does not support voice announce calls. If the SV8100 is set to voice in Program

20-02-12, each phone should dial use access code 723 to set the phone to ring on internal
calls. The ML440 should also be put in their own class of service with Program 20-08-11
enabled.
In a single base (AP20) system the AP20 supports a maximum of 10 simultaneous voice

paths.
The ML440 and AP20 system uses NEC i-SIP for SV8100.

The ML440 and AP20 system supports the G.711 CODEC only.

The ML440 Handset and AP20 Access Point are not supported in UX5000 or UX5000

Migration systems.
The ML440 Handset and AP20 Access Point do not support peer to peer operation.

The ML440 Handset does not support the Live Monitor feature.

The line keys on the ML440 correspond to Line Keys 1-4 in Program 15-07-01 for that

phones extension.
The three dedicated soft keys are predefined depending on the state of the call.

The ML440 will follow the ring no answer timing whenever the ML440 handset either is

turned off or is out of range of an AP20.
IP Multiline Station (SIP) – ML440 Cordless
ML440
Yes
Yes Voice mail softkeys are not provided to the ML-440
Handset.
Yes
Yes ML-440 can initiate voice over but cannot respond
to voice from another extension.
Yes By nature, this is a SIP device.
Yes
No Volume control is a function of the ML-440 Handset
and not the phone system.
Issue 11.0
Comment
2 - 795