Connecting The Ethernet Cable To The Projector - Christie Mirage SST Installation And Setup Manual

11. To lock the fiber in place, rotate the locking collar clockwise until you see the locking pin start
to turn and no longer moves forward and then rotate the knurled ring clockwise.
12. Attach the strain relief to the projector and tighten the two screws to secure it.
13. Wrap the fiber optic cable inside the protective pad and position in the groove.
14. Install the back portion of the clamp over the fiber optic cable and tighten the four screws
removed in step 5.

Connecting the Ethernet cable to the projector

Connect the projector to the laser illumination source with an Ethernet cable.
1. Connect one end of an Ethernet cable to the Laser Rack network port on the IMXB of the
projector.
Mirage SST Installation and Setup Guide
020-102956-08 Rev. 1 (09-2022)
Copyright © 2022 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
Installation and setup
38