Ethernet Communications - Christie CineIPM-2K User Manual

INSTALLATION AND SETUP
suited for long distances than is RS232 communication. Note that RS422 is not
compatible with RS232—connecting a RS232-compatible PC to RS422 can damage
the equipment at either end. Consult the documentation provided with your PC if you
are unsure.
The 9-pin RS422 connector is located on the front input panel of the Cine-IPM 2K.
When using this port, make sure to set the baud rate to match that of your RS422
controlling device.
Figure 2.16. Connecting Serial Communications via RS422
CAUTION
Do not use an RS422 port unless you are using
equipment with RS422 capability. The voltage levels of
this signal can damage incompatible equipment.

Ethernet Communications

To add the Cine-IPM 2K to an Ethernet network with other equipment such as
controllers and other projectors, connect standard CAT5 Ethernet cable between your
Ethernet controller (or hub) and the Ethernet port on the Cine-IPM 2K front panel.
NOTES: 1) Ethernet crossover cable required if connecting directly to a PC only. 2)
Downloading new software to the projector via Ethernet is not supported.
2-12 Cine-IPM 2K User's Manual
020-100164-01 Rev. 1 (01/08)