Ypbpr Signals (Component Video); Composite Video - Christie Roadie HD+35K Setup Manual

2.4.2 YPbPr Signals (Component Video)

Connect a YPbPr signal (component video) to INPUT 1
or INPUT 2 as shown in
If, for some reason, the projector fails to
NOTES: 1)
recognize a YPbPr signal, specify this Color Space
option within the Image Settings menu. Refer to
Section 3.6.3 Image Settings Menu in the
Roadie HD+35K User Manual.
connect digital component signals (known as
YCbCr) to INPUT 1 or INPUT 2. Use the
appropriate optional digital interface installed in
INPUT 5 or 6 only.

2.4.3 Composite Video

INPUT 3 and INPUT 4 provide simultaneous connection
of both a composite video source (INPUT 3 and an S-
Video source (INPUT 4). Refer to
Unlike previous Christie projectors, composite
NOTE:
video and S-Video cannot connect to any other
locations on the input panel. Connect as shown in
Figure 2-20
Roadie HD+35K Setup Guide
020-100394-02 Rev. 1 (01-2010)
.
Figure 2-19.
Do not
2)
Figure 2-20.
.
Section 2: Installation and Setup
Signals
from YPbPr
source
A.k.a.:
• Component
Input 1
• YUV
• Y, R-Y, B-Y
Vert
Sync
Hor /
Comp
Pb
Blue
Y Green
Red
Pr
29-pin DVI-I
Connector
Input 2
DVI
Input 3
To YPbPr
Video
source
Input 4
S-Video
Ethernet
Remote
RS422 GPIO
RS232 RS232
OUT
IN
Figure 2-19 Connecting a YPbPr Source
Input 5
(Opt. 1)
Input 6
(Opt. 2)
2-17