Setting input ports using menu
Inputting image from Main to Sub
- Video signal (either component or video)
1.
If the STACK menu is already displayed on the screen, proceed to 3 below.
Otherwise press the MENU button on the remote control.
If the MENU dialog is displayed, use the ▲/▼ buttons to highlight MAIN, and
press the ► button. A menu will be displayed.
If the MENU dialog is not displayed, the STACK menu will appear.
2.
Press the MENU button on the remote control
or control panel on the Main projector.
Use the ▲/▼/◄/► buttons to open the
COMPUTER IN dialog.
(Operating Guide → INPUT menu)
3.
To input component signals to COMPUTER IN1* or IN2*, set the port to
AUTO. Then, use the ▲/▼/◄/► buttons to highlight EXIT and press the ►
button to complete the setting.
To input video signals to COMPUTER IN1* or IN2*, set the port to VIDEO. If it
is necessary to select a video format, use the ▲/▼/◄/► buttons to highlight
RETURN and press the ◄ button to display the INPUT menu. Otherwise, use
the ▲/▼/◄/► buttons to highlight EXIT and press the ► button to complete
the setting.
4.
Select VIDEO FORMAT in the INPUT menu
to display the VIDEO FORMAT dialog.
Select AUTO or an appropriate format
for the video signal input.
Then, use the ▲/▼/◄/► buttons to
highlight EXIT and press the ► button
to complete the setting.
*) For DHD951, COMPUTER IN
DWU951/DHD951/DWX951/DXG1051 User's Manual - Instant Stack Guide
DWU951/DWX951/DXG1051
DWU951/DWX951/DXG1051
26
DHD951
DHD951
020-000663-02 Rev. 1 (06-2014)