Stacking Procedure - Christie Roadster S+14K-J User Manual

4. Attach rigging hardware.
Attach the rigging hardware by securing your rigging
components to the appropriate rigging points. There
are 8 sliding points provided on the bottom. Tighten
the nut at each required location
prevent sliding.
NOTES: 1) Use at least 4 rigging points for all hoisting.
2) Use straps, clamps or cabling with load
capacity adequate for the total projector weight.
Refer to Section
the rigging straps or cables to a common point,
keep separated as shown.

2.2.4 Stacking Procedure

NOTES: 1) Installation requires at least 2 people.
Projectors can be stacked in either the upright or inverted position. Do not mix orientations (i.e., inverted
with upright) in a stack. Secure a maximum of 3 projectors with the stacking mounts as described below.
J Series 2.0, 2.4, and 3.0kW User Manual
020-100707-01 Rev. 1 (10-2011)
(Figure
7 Specifications. 3) Do not join
• Maximum stack = 3 projectors
• Stack first, then hoist
Do not stack more than 3 projectors.
Christie stacking hardware required. The top projector could slide off and cause injury
or death.
Never attempt to manually carry a stack.
2-16) to
Figure 2-16 Using the Rigging Hardware
Section 2: Installation and Setup
2-13