Lamp And Filter Replacement - Christie J Series Setup Manual

4 Maintenance
4.1

Lamp and Filter Replacement

Lamp
Do not operate the lamp for more than the warranty limit; risk of the lamp shattering increases as a result of
changes in the quartz glass that occur with use. Operation beyond the lamp warranty limit also significantly
reduces brightness output.
Lamp Replacement Procedure
For this procedure you will need the appropriate Lamp and Filter Kit manufactured by Christie Digital
Systems. See Table
Table 4.1
Projector Part Number
Roadster S+14K-J
Mirage S+14K-J
Roadster HD14K-J
Mirage HD14K-J
Mirage WU14K-J
Matrix WU14K-J
J Series 2.0, 2.4, and 3.0 kW Setup Guide
020-100751-01 Rev. 1 (10-2011)
Wait approximately 5 minutes after powering down the projector to allow the lamp to
cool sufficiently before removing.
Never attempt to remove the lamp housing directly after use. The lamp is under great
pressure when hot and may explode, causing personal injury and/or property damage.
Use only lamps supplied by Christie.
Select the correct wattage lamp supplied by Christie. See
replacement procedure in its entirety before proceeding.
A Christie accredited service technician must perform lamp replacement.
Cool the lamp completely, then lift the lamp by the handle only.
Do not touch the glass window of the lamp. Fingerprints left on the surface can lead to
an intense accumulation of heat called a "hotspot," which could potentially result in
lamp failure. It is recommended you wear a face shield when working with the lamp.
4.1.
Projector Model
132-010113-xx
132-010124-xx
132-011114-xx
132-011125-xx
132-012126-xx
132-012137-xx
Lamp Type
2.0 kW
Table 4.1 . Read the lamp
Lamp/Filter Kit Required
003-120135-xx
4-1