Silicon Graphics SGI 1100 Maintenance And Upgrade Manual page 78

2: Removing and Replacing System Components
62
5. If the type of Phillips screwdriver you are using does not allow you to perform the
procedure shown in step 4, follow these alternative steps:
– Using needle-nose pliers, hold one of the screws through the hole in the drive
module.
– With your other hand, tighten the screw with a small Phillips screwdriver.
– Repeat this procedure for the other screw.
6. Install the diskette drive module as described in "Installing the Diskette
Drive/CD-ROM Drive Module" on page 54.
7. Install the chassis cover as described in "Installing the Chassis Cover" on page 23.
007-4047-001