Replacing The Cmos Battery; Figure 2-54 Replacing The Cmos Battery - Silicon Graphics SGI 1100 Maintenance And Upgrade Manual

Table of Contents

Advertisement

Replacing the CMOS Battery

007-4047-001
Follow these steps to replace the CMOS battery:
1.
Remove the chassis cover as described in "Removing the Chassis Cover" on
page 21.
2. Push on the retaining clip and remove the old battery from its holder, as shown in
Figure 2-54.
3. Push the new battery into its holder until the retaining clip snaps into place.
4. Install the chassis cover as described in "Installing the Chassis Cover" on page 23.
Note: The system uses a standard CR2032 3V lithium coin-cell battery.
Figure 2-54
Replacing the CMOS Battery
CMOS battery
Retaining clip
Replacing the CMOS Battery
91

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SGI 1100 and is the answer not in the manual?

Table of Contents