Silicon Graphics SGI 1100 Maintenance And Upgrade Manual page 122

3: Troubleshooting
106
Table 3-3 (continued)
Error Message
On-board Serial Port 1
Conflict(s)
On-board Serial Port 2
Conflict(s)
Real Time Clock Error
CMOS Battery Bad
CMOS Checksum Error
On-board xxx...Conflict(s)
PCI Device Error
System Resource Conflict
IRQ Setting Error
Expansion ROM Allocation
Fail
POST Error Messages
Possible Cause
On-board serial port address
conflicts with the add-on card
serial port.
Real-time clock error.
CMOS battery power lost.
CMOS RAM error.
On Board device resources
(e.g., IRQ, DMA, I/O address)
conflict.
PCI device may be bad.
Some system resources conflict
with the resources required by
the PCI device.
Wrong IRQ setting for the PCI
device.
The I/O expansion ROM fails
to allocate for the PCI device.
Corrective Action
Change the on-board serial
port address in Setup or
change the add-on card serial
port address.
Check RTC circuit or replace
the RTC.
Replace the on-board lithium
battery.
Run Setup again and
reconfigure the system.
Try to reassign or disable
on-board device resources.
Check the PCI card. Replace if
bad.
Run Setup to reconfigure the
system.
Run Setup to reconfigure the
system.
Change the I/O expansion
ROM address.
007-4047-001