Configuring Query Interval, Max Response Time And General Query Source Ip - TP-Link T1600G-18TS Configuration Manual

Configuring Layer 2 Multicast
Step 2 ip igmp snooping querier vlan vlan-id
vlan-id
Step 3 show ip igmp snooping querier [vlan vlan-id ]
Show the IGMP querier configuration.
Step 4 end
Return to privileged EXEC mode.
Step 5 copy running-config startup-config
Save the settings in the configuration file.
The following example shows how to enable IGMP Snooping and IGMP Querier in VLAN 4:
Switch#configure
Switch(config)#ip igmp snooping
Switch(config)#ip igmp snooping querier vlan 4
Switch(config)#show ip igmp snooping querier
VLAN 4:
--------------
Maximum Response Time:
Query Interval:
General Query Source IP:
Switch(config)#end
Switch#copy running-config startup-config

Configuring Query Interval, Max Response Time and General Query Source IP

Step 1 configure
Enter global configuration mode.
Step 2 ip igmp snooping querier vlan vlan-id {query-interval interval | max-response-time
response-time | general-query source-ip ip-addr }
vlan-id
interval
response-time
to 25 seconds.
ip-addr
be a multicast address or a broadcast address.
specifies the VLAN to enable IGMP Querier.
10
60
192.168.0.1
specifies the VLAN where the querier is.
is the interval between general query messages sent by the querier.
is the host's maximum response time to general query messages in a range of 1
is the source IP address of the general query messages sent by the querier. It cannot
IGMP Snooping Configurations
Configuration Guide 300