Rule - TP-Link JetStream T3700G-52TQ Cli Reference Manual

T3700G-52TQ JetStream 52-Port Gigabit Stackable L3 Managed Switch CLI Guide
255.255.255.0, the time-range for the rule to take effect is tSeg1, and the
packets match this rule will be forwarded by the switch:
T3700G-52TQ(config)#access-list create 110
T3700G-52TQ(config)#access-list extended 110 rule 10 permit sip
192.168.0.100 smask 255.255.255.0 tseg tSeg1

29.8 rule

Description
The rule command is used to configure MAC ACL rule. To delete the
corresponding rule, please use no rule command.
Syntax
rule
[dmac
[pri
[qos-remark
ten-gigabitEthernet
redirect-port
no rule
Parameter
rule-id
deny —— The operation to discard packets.
permit ——The operation to forward packets. By default, it is "permit".
source-mac
source-mac-mask
typed the source MAC address.
destination-mac
destination-mac-mask
if you typed the destination MAC address.
ethernet-type
number.
user-pri
default, it is not limited.
time-segment
not limited.
rule-id
{deny | permit} [smac
destination-mac
dmask
user-pri time-segment
] [tseg
value
] [ s-mirror interface { gigabitEthernet
mirror-port
| ten-gigabitEthernet
rule-id
—— The rule ID.
—— The source MAC address contained in the rule.
—— The source MAC address mask. It is required if you
—— The destination MAC address contained in the rule.
—— The destination MAC address mask. It is required
—— EtherType contained in the rule, in the format of 4-hex
—— The user priority contained in the rule, ranging from 0 to 7. By
—— The time-range for the rule to take effect. By default, it is
source-mac
smask
destination-mac-mask
vlan-id
] [vid ] [s-condition
} | redirect interface { gigabitEthernet
redirect-port
}]
228
source-mac-mask
]
ethernet-type
] [type
rate-limit
]
mirror-port
|
]