Configuring Acl Rules; Configuring Mac Acl Rule - TP-Link T1600G-52TS User Manual

Configuring ACL
Note:
The supported ACL type and ID range varies on different switch models. Please refer to the on-screen
information.

2.1.3 Configuring ACL Rules

Note:
Every ACL has an implicit deny all rule at the end of an ACL rule list. That is, if an ACL is applied to a
packet and none of the explicit rules match, then the final implicit deny all rule takes effect and the
packet is dropped.
The created ACL will be displayed on the SECURITY > ACL > ACL Config page.
Figure 2-2 Editing ACL
Click Edit ACL in the Operation column. Then you can configure rules for this ACL.
The following sections introduce how to configure MAC ACL, IP ACL, Combined ACL and
IPv6 ACL.

Configuring MAC ACL Rule

Click Edit ACL for a MAC ACL entry to load the following page.
Figure 2-3 Configuring the MAC ACL Rule
In ACL Rules Table section, click and the following page will appear.
ACL Configuration
User Guide 669