Show Supervlan Ip-Pool - Zte ZXR10 Command Manual

Example
Purpose
Command Modes
Syntax
Instructions
� For ZXR10 T1200/T600//T128/T64E, the parameter <supervl
an-id> ranges from 1 to 4096.
� For the switch series, such as ZXR10 5928, the parameter
ranges from 1 to 255.
� Use the show supervlan [<supervlan-id>] command on the
router to display information about the configuration of Super-
PVC. <supervlan-id> ranges from 1 to 64.
� This example describes how to displays information about con-
figurations of all SuperVLAN interfaces.
ZXR10(config)# show supervlan 2
interface supervlan2
inter-subvlan-routing enable
arp-broadcast disable
ip-pool-filter enable
fei_1/2.1 inner-vlan-id 1
fei_1/2
The displayed information descriptions are displayed as fol-
lows.
Field
inter-subvlan-
routing
subvlan
Arp-broadcast
Ip-pool-filter
SuperVLAN
fei_1/2.1 inner-vlan
1 outer-vlan 2
� The information about VLAN range or QinQ range is displayed
as follows.
ZXR10(config)#show supervlan 2
interface supervlan2
inter-subvlan-routing enable
arp-broadcast disable
ip-pool-filter enable
fei_1/2.2 inner-vlan 20-40

show supervlan ip-pool

Use this command to display the IP POOL bound to the VLAN.
All modes
show supervlan ip pool
Use show superpvc ip-pool command on the router to display
the IP-pool configuration on ATM sub interface of Superpvc.
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 4 SuperVLAN Configuration
outer-vlan-id 2
Description
Enables or disables routing between
sub-vlans
Sub-Vlans under the supervlan interface
ARP broadcast status
IP POOL filter flag
Supervlan identifier
The sub interface bound. If it is a virtual
interface, then the encapsulated VLAN
ID and QinQ are given. If it is a physical
interface, there is no encapsulated content
outer-vlan 60-80
49