Auto-Summary; Default-Metric - Zte ZXR10 8900 Series Command Reference Manual

All manuals and user guides at all-guides.com
ZXR10 8900 Series Command Reference (IP Routing Volume I)
Router configuration
Command Modes
address-family ipv4 vrf <vrf-name>
Syntax
no address-family ipv4 vrf <vrf-name>
Syntax
Description
<vrf-name>
Invalid
Defaults
The RIP extension supports the VRF address mode. The corre-
Instructions
sponding address configuration mode should be entered to config-
ure the address mode.
This example describes how to enter the vpn1 address mode.
Example
ZXR10(config)#router rip
ZXR10(config-router)#address-family ipv4 vrf vpn1
ZXR10(config-router-af)#

auto-summary

Use this command to configure to send the route which only passes
Purpose
through the summarized nature network and super network routes
(in RIPV2). To send all RIP routes, use the no command.
Router configuration and address family configuration
Command Modes

auto-summary

Syntax
no auto-summary
Enable
Defaults
�
Instructions
�

default-metric

Use this command to re-distribute the other protocol generated
Purpose
routes as the default metric for the RIP route. To restore default,
use the no command.
Router configuration and address family configuration
Command Modes
default-metric <metric-value>
Syntax
no default-metric
10 Confidential and Proprietary Information of ZTE CORPORATION
VRF name, 1~16 characters
The route summary reduces the route information volume to
be sent.
Even if the command auto-summary is configured, Please
mention the following policies which are still effective:
Router has an interface address and this interface address in
a natural network segment, which is a sub network segment
of RIP protocol. RIP update packet sends from this interface
without natural network routing, but with other RIP sub net-
work routings, which belong to a different sub network with
the interface.