Show Vlanresource-Summary; Shutdown - Zte ZXR10 Command Manual

Syntax
Description
Example
Purpose
Command Modes
Syntax
Instruction
Example
Purpose
Command Modes
Syntax
Defaults
Instructions
Example
<port-name>
This example describes how to diagnose line gei_3/1.
ZXR10(config)#show vct interface gei_3/1
CableStatus Fault
Pair 1-2
Status Open
Length 4m

show vlanresource-summary

Use this command to display the interface type, slot number, in-
terface number and total.
Interface configuration and EXEC

show vlanresource-summary

This command on the router can display the already set ether-
net interface and partial logical interfaces(SuperVLAN, SuperPVC,
SmartGroup, MPPP, tunnel, loopback, null).
This command on the switch only supports VLAN interface.
This example shows how to execute this command on the switch.
ZXR69_121#show vlanresource-summary
Porttype Slot
VLAN NA
TOTAL

shutdown

Use this command to start or shut down an interface.
Interface configuration

shutdown

no shutdown
The default state of interface is start.
The command shutdown is to shut down an interface (to disable
all functions), which has nothing to do with the physical status (up
or down) of an interface.
This example describes how to start serial port serial_1/1.
ZXR10(config)#interface serial_1/1
ZXR10(config-if)#no shutdown
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 2 Interface Configuration
Port name
3-6 4-5
Open Good Good
4m <50m
Number
4
4
7-8
<50m
59