Lower feed roller assembly and lower feed roller electric clutch
Tools required
Magnetic screwdriver
#2 Phillips tip
1.
Turn off the printer and remove the power cord.
2.
Remove the right-side and left-side covers as explained in the earlier
topic, "Cabinet panels and covers" on page 8-4. Open the front cover.
3.
Remove the maintenance tray.
4.
Left side. Disconnect the wiring harness leading from the clutch to
I/O board 1.
5.
At the electric clutch, remove the left-side E-clip securing the left end
of lower feed roller shaft.
6.
Remove the feed roller magnetic clutch.
7.
Right side. Release the paper-pick's wiring harness leading from the
feed roller assembly to I/O board 2.
8.
Remove the E-clip securing the right end of the lower feed roller shaft.
9.
Remove the bushing at each end of the lower feed roller shaft.
Remove the lower feed roller assembly.
Field Replaceable Unit Disassembly/Assembly
Needle nose-pliers
Small, flatblade screwdriver
Service Manual
8
8-55