Printhead Transit Restraint Assembly - Tektronix Phaser 380 Service Manual

Printhead transit restraint assembly

Tools required
Magnetic screwdriver
#2 Phillips tip
1.
Turn off the printer and remove the power cord.
2. Remove the top and left-side and right-side covers as explained in the
earlier topic, "Cabinet panels and covers" on page 8-4.
3. Remove the ink loader as explained in the earlier topic, "Ink loader"
on page 8-9.
4. Disconnect the printhead's power wiring harness and ground wire.
5. Disconnect the data ribbon cable leading from the printhead to J13 of
the power control board.
Warning
The printhead is hot.
Field Replaceable Unit Disassembly/Assembly
Needle-nose pliers
Service Manual
8
8-41