Figure 8-22 Removing The Y-Axis Motor - Tektronix Phaser 380 Service Manual

8
Field Replaceable Unit Disassembly/Assembly
Y-axis (drum) motor
Ferrite coil
mounting
bracket

Figure 8-22 Removing the Y-axis motor

8-34 Phaser 380 Color Printer
Tools required
Magnetic screwdriver
#2 Phillips tip
1. Turn off the printer and remove the power cord.
2. Open the front door and remove the drum maintenance cartridge.
3.
Remove the front panel, right-side and left-side covers as explained in
the earlier topic, "Cabinet panels and covers" on page 8-4.
4. Remove the Y-axis belt drive assembly as explained in the previous
procedure, "Y-axis belt drive assembly" on page 8-16.
5. Remove the paper preheater as explained in the previous procedure,
"Paper preheater" on page 8-21.
6. Disconnect the motor's wiring harnesses from the power control
board. The Y-axis motor connect to J15.
7. Remove the four screws securing the motor to the drum/transfix
assembly. Remove the motor by carefully lowering it out the front of
the printer.
8. Remove the ferrite coil mounting bracket from the end of the motor.
Y-axis
motor
Reverse these steps to install the Y-axis motor, transferring the ferrite coil to the
new motor.
Remove
4 screws
Wiring
harness
9661-48