Postscript Code Rom Simm; Figure 8-48 Installing The Postscript Code Rom Simm On The Main Board - Tektronix Phaser 380 Service Manual

8
Field Replaceable Unit Disassembly/Assembly

PostScript Code ROM SIMM

8-72 Phaser 380 Color Printer
1.
Power down the printer. Leave the power cord plugged in to provide
a ground path for static discharges.
2. Loosen the main board's two rear panel securing screws.
3. Slide out the main board.
4.
Remove the currently installed code ROM SIMM by spreading apart
the pawls securing each end of the SIMM in connector P71 ROM
SIMM. Remove the SIMM.
5. Insert a replacement code ROM SIMM in connector P71 (a), and tilt
the SIMM down until it locks in place (b).
When properly inserted, a tab on each end of the connector slips into a
hole on each end of the code ROM SIMM. Also, a pawl on each end of
the connector latches around each end of the SIMM to lock it in place.
a b

Figure 8-48 Installing the PostScript code ROM SIMM on the main board

6. Reinstall the card cage top and the rear cabinet panels.
7. Reconnect the host interface cables. Turn on the printer and make a
test print.
Code
ROM
SIMM
9661-46