Tektronix Phaser 380 Repacking Manual

Repacking the Color Printer
and its Accessories

Overview

It is very important that you follow the correct repacking procedure before shipping your color printer.
Failure to properly repack the printer can cause damage to the printerÕs internal components. You are
responsible for any shipping damage to the printer that results from improper or inadequate
packaging.
Repacking for shipment consists of four basic tasks. Each of these tasks is explained in this instruction
sheet. If you have questions regarding any of the repacking procedures, call the Tektronix Customer
Support Hotline at 1-800-835-6100 .
Turn off the printer using the On/Off switch and wait 45 minutes before moving it to
allow the ink to solidify.
Remove the maintenance tray, seal it in a plastic bag, and store the tray on a ßat
surface. A used maintenance tray leaks drum fluid if tipped.
Lock the printhead transit restraint on the right side of the printer.
Repack the printer and its accessories using Tektronix-approved packing materials.

Turning off the printer

Use the rear-panel On/Off switch located on the rear of the printer to turn it off.
1.
This places the print head in the proper position for locking (described later in this
document), which is necessary for safe shipment. Do not turn off the printer by
pulling the power cord.
Caution
To avoid damaging the printer's internal components, always turn the printer
power off using the On/Off switch before moving or shipping the printer. Failure
!
to do so may result in damage to the printers' internal components during
shipment.
After turning off the printer, let it cool down for at least 45 minutes before you move
2.
it so that the melted ink inside the printer has time to solidify.
Disconnect the power cord and other cables from the printer.
3.
Unload any media present in the media tray. Install the tray in the printer.
4.
If present, disconnect the Lower Paper Tray Assembly cable from the printer.
5.
©
Copyright 1997 by Tektronix, Inc. All rights reserved. 063-2659-00