Figure 8-29 Removing The X-Axis Drive Assembly - Tektronix Phaser 380 Service Manual

Printhead home Cover plate
position sensor screws
wiring
I/O board 1
X-axis drive
assembly

Figure 8-29 Removing the X-axis drive assembly

Reverse this procedure to reinstall the X-axis drive assembly. Perform these
adjustments:
X-axis parallelism, refer to "X-axis rails-to-drum parallelism
adjustment" on page 9-14.
Printhead to drum spacing, refer to "Printhead-to-drum spacing
adjustment" on page 9-16.
Skip and scan, refer to "Adjusting the vertical interleave (scan shift)"
on page 9-34 and "Adjusting the horizontal image interleave (skip)"
on page 9-32.
Scale factor, refer to "Adjusting scale and skip factors" on page 9-28
Printhead restraint, refer to "Printhead transit restraint adjustment"
on page 9-22.
Field Replaceable Unit Disassembly/Assembly
X-axis drive Printhead
cover plate restraint
bracket
Cover plate
screws
Service Manual
8
Do not
remove
black plug
9661-28
8-45