Paper Tray Media Sensor Board; Figure 8-44 Removing The Tray Media Sensor Board - Tektronix Phaser 380 Service Manual

Paper tray media sensor board

Tools required
Magnetic screwdriver
1. Turn off the printer and remove the power cord.
2. Remove the right-side cover as explained in the earlier topic, "Cabinet
panels and covers" on page 8-4.
3.
Disconnect the wiring harnesses leading to the media sensor board.
4. Remove the three screws securing the media sensor board to the
engine frame. Remove the board.

Figure 8-44 Removing the tray media sensor board

Field Replaceable Unit Disassembly/Assembly
#2 Phillips tip
Paper tray
media sensor
Service Manual
8
9661-41
8-67