I/O Board 2 And I/O Board - Tektronix Phaser 380 Service Manual

I/O board 2 and I/O board 3

Tools required
Magnetic screwdriver
1. Turn off the printer and remove the power cord.
2. Remove the right-side cover as explained in the earlier topic, "Cabinet
panels and covers" on page 8-4.
3. I/O board 2:
a. Disconnect the wiring harnesses leading to I/O board 2.
b. Remove the four screws securing I/O board 2 to the engine frame.
c. Remove the board.
4. I/O board 3:
a. Remove the frame support by removing the five screws securing it
in place.
a. Disconnect the wiring harnesses from I/O board 3.
Field Replaceable Unit Disassembly/Assembly
#2 Phillips tip
Service Manual
8
8-65