Rep 9.8 Erase Lamp; Rep 9.9 Dry Ink Cartridge - Xerox Phaser 790 Service Manual

REP 9.8 Erase Lamp

Parts List on PL 5.1
Removal
To avoid personal injury or shock, do not perform repair activities with the power switch
on or electrical power applied to the machine.
1. Switch off the machine power and disconnect the machine Power Cord.
2. Remove the Locating Rail (REP 9.5).
3. Remove the Erase Lamp (Figure 1).
Replacement
1. Reinstall the Erase Lamp in the reverse order of removal.
2
Unhook the lamp
from the rail by
compressing the
tabs
Figure 1 Removing the Erase Lamp
Initial Issue
Phaser 790/DocuColor 2006
WARNING
3
Remove the Erase Lamp
1
Pull the harness through
the hole

REP 9.9 Dry Ink Cartridge

Parts List on PL 6.2
Removal
To avoid personal injury or shock, do not perform repair activities with the power switch
on or electrical power applied to the machine.
1. Switch off the machine power and disconnect the machine Power Cord.
2. Remove the appropriate Dry Ink Cartridge (Figure 1).
After removing, be sure to lay the Dry Ink Cartridge in its horizontal position in a safe place.
Replacement
1. Place the arrow on the end of the Dry Ink Cartridge facing toward the top in order to insert
the cartridge.
2. Reinstall the Dry Ink Cartridge in the reverse order of removal.
5
Remove the Dry Ink
Cartridge
Figure 1 Removing the Dry Ink Cartridge
10/00
4-97
WARNING
CAUTION
2
Lift and hold the lever
during the following step
3
Turn the knob to
access the car-
4
tridge to be
Turn the knob
removed
to release the
cartridge
Repairs and Adjustments
REP 9.8, REP 9.9
1
Open the Front
Cover Assembly