Rep 8.10 Lift Plate Sensor; Rep 8.11 Lift Frame Assembly - Xerox Phaser 790 Service Manual

REP 8.10 Lift Plate Sensor

Parts List on PL 4.2
Removal
To avoid personal injury or shock, do not perform repair activities with the power switch
on or electrical power applied to the machine.
1. Switch off the machine power and disconnect the machine Power Cord.
2. Remove the Bypass Tray/Registration Assembly. (REP 8.6)
3. Remove the Bypass Tray Feed Assembly (REP 8.7)
4. Remove the Tray Housing (REP 8.8)
5. Remove the Lift Frame Assembly. (REP 8.11)
6. Remove the Lift Plate Sensor. (Figure 1)
3
Disconnect
the connector
2
Set the Lift Down Actuator to
the up position and secure it
Figure 1 Removing the Lift Plate Sensor
Replacement
1. Perform the procedure for removal in reverse.
Repairs and Adjustments
REP 8.10, REP 8.11
WARNING
4
Release the locking
tabs and remove the
Lift Plate Sensor
1
Lift and remove the
Bottom Plate

REP 8.11 Lift Frame Assembly

Parts List on PL 4.2
Removal
To avoid personal injury or shock, do not perform repair activities with the power switch
on or electrical power applied to the machine.
1. Switch off the machine power and disconnect the machine Power Cord.
2. Remove the Bypass Tray/Registration Assembly. (REP 8.6)
3. Remove the Bypass Tray Feed Assembly (REP 8.7)
4. Remove the Tray Housing (REP 8.8)
5. Remove the Lift Frame Assembly. (Figure 1)
2
Remove three screw and the Lift
Frame Assembly
Figure 1 Removing the Lift Frame Assembly
Replacement
1. Perform the procedure for removal in reverse.
NOTE: Install so that the boss of the Bypass Tray Frame is aligned with the hole on the left
side of the Lift Frame Assembly.
10/00
4-66
WARNING
1
Disconnect the
connector
Phaser 790/DocuColor 2006
Initial Issue