Rep 6.19 Belt; Rep 6.20 Lamp - Xerox Phaser 790 Service Manual

REP 6.19 Belt

Parts List on PL 16.4
Removal
To avoid personal injury or shock, do not perform repair activities with the power switch
on or electrical power applied to the machine.
1. Switch off the machine power and disconnect the machine Power Cord.
2. Remove the Carriage Motor (REP 6.18).
3. Remove the Belt (Figure 1).
1
Remove the Belt
Figure 1 Removing the Belt
Replacement
1. Perform the procedure for removal in reverse.
Repairs and Adjustments
REP 6.19, REP 6.20
WARNING

REP 6.20 Lamp

Parts List on PL 16.5
Removal
To avoid personal injury or shock, do not perform repair activities with the power switch
on or electrical power applied to the machine.
1. Switch off the machine power and disconnect the machine Power Cord.
2. Remove the Platen Glass (REP 6.1).
3. Move the Full-rate Carriage so that it is aligned with the notches in the center of the scan-
ner frame.
4. Remove the Lamp (Figure 1).
2
Remove the screw and then remove the
Lamp by turning it in the direction indicated
Figure 1 Removing the Lamp
Replacement
1. Perform the procedure for removal in reverse.
10/00
4-50
WARNING
1
Disconnect the
connector
Phaser 790/DocuColor 2006
Scanner
frame
Notches
Initial Issue