Rep 10.17 Exit Roll - Xerox Phaser 790 Service Manual

REP 10.17 Exit Roll

Parts List on PL 8.4
Repair
To avoid personal injury or shock, do not perform repair activities with the power switch
on or electrical power applied to the machine.
1. Switch off the machine power and disconnect the machine Power Cord.
2. Remove the Exit Tray Assembly (REP 8.30).
3. Remove the Fuser Assembly (REP 10.1).
4. Remove the Main Fuser Assembly (REP 10.2).
The rear Exit Roll Bearing remains but is not secured to the tray when the following step of the
procedure is performed. Be careful not to lose the bearing.
5. Remove the Exit Roll (Figure 1).
Replacement
1. Reinstall the Exit Roll in the reverse order of removal.
3
Move the Bearing
and then disen-
gage the Exit Roll
4
Remove the Exit Roll
Figure 1 Removing the Exit Roll
Initial Issue
Phaser 790/DocuColor 2006
WARNING
CAUTION
1
Remove the e-ring
2
Move the gear and
then remove the Pin
5
Remove the
Exit Gear and
Exit Bearing
from the Exit
Roll
10/00
4-125
Repairs and Adjustments
REP 10.17