3.
Remove the Entrance Tray Assembly. (Figure 2)
2
Lift the tray and disconnect the
connector from the Document
Set Indicator
Figure 2 Removing the Entrance Tray
4.
Remove the Transport Assembly. (REP 5.7)
Repairs and Adjustments
ADJ 5.4
5.
Measure the distance from the ADF Rear Frame to the front end of the Paper Side Guide.
(Figure 3)
NOTE: Make sure the ruler is positioned
1
at a right angle to the frame
Remove the
screws (2)
3
Remove the tray
6.
If the measurement is not within specifications perform the adjustment.
10/00
4-152
1
Take a measurement at
the point close to the Tie
Plate, left to right. The
distance should be 19mm
Figure 3 Taking Measurements
Phaser 790/DocuColor 2006
Initial Issue