Rep 9.12 Rotary Frame - Xerox Phaser 790 Service Manual

REP 9.12 Rotary Frame

Parts List on PL 6.1
Removal
To avoid personal injury or shock, do not perform repair activities with the power switch
on or electrical power applied to the machine.
1. Switch off the machine power and disconnect the machine Power Cord.
2. Remove the Front Cover Assembly (REP 14.1).
3. Remove the Top Cover Assembly (REP 14.4).
4. Remove the Copy/Print Cartridge (REP 9.1).
5. Remove the Tension Lever (REP 9.15).
6. Remove the Left Inner Cover Assembly (REP 14.5).
7. Remove the Rear Cover (REP 14.6).
8. Remove all Dry Ink Cartridges (REP 9.9).
9. Remove the Left Front Cover Interlock (REP 1.7).
10. Remove all Developer Housings (REP 9.10).
11. Remove the Rotary Sensor (REP 9.11).
12. Remove the Fuser Assembly (REP 10.1).
13. Remove the Exit Transport Assembly (REP 8.40).
14. Remove the Rotary Motor PWB (REP 4.8).
15. Remove the Rotary Motor (REP 4.7).
16. Remove the Dispense Clutch (REP 4.9).
17. Remove the LVPS (REP 1.1).
18. Remove the Fuser Drive Unit (REP 4.2).
19. Remove the Developer Clutch (REP 4.10).
20. Remove the Developer Tie Plate (REP 9.14).
Repairs and Adjustments
REP 9.12
WARNING
21. Remove the Rotary Knob (Figure 1).
2
Disengage the knob
with a screwdriver
1
Remove the screw
Figure 1 Removing the Rotary Knob
10/00
4-100
3
Remove the Rotary Knob
Initial Issue
Phaser 790/DocuColor 2006