Rep 10.18 Fuser Entrance Sensor - Xerox Phaser 790 Service Manual

REP 10.18 Fuser Entrance Sensor

Parts List on PL 8.6
Removal
To avoid personal injury or shock, do not perform repair activities with the power switch
on or electrical power applied to the machine.
1. Switch off the machine power and disconnect the machine Power Cord.
2. Remove the Fuser Assembly (REP 10.1).
3. Prepare to remove the Fuser Entrance Sensor (Figure 1).
1
Remove the screws
Figure 1 Preparing to Remove the Fuser Entrance Sensor
Repairs and Adjustments
REP 10.18
WARNING
2
Remove the Fuser Paper
Guide and Horizontal Chute
3
Remove the screws,
and then remove
the Bottom Cover
4. Remove the Fuser Entrance Sensor (Figure 2).
Replacement
1. Reinstall the Fuser Entrance Sensor in the reverse order of removal.
1
Disengage and
remove the Sensor
Bracket
3
Disengage and
remove the
Fuser Entrance
Sensor
Figure 2 Removing the Fuser Entrance Sensor
10/00
4-126
2
Disconnect the
connector
Initial Issue
Phaser 790/DocuColor 2006