Rep 6.18 Carriage Motor - Xerox Phaser 790 Service Manual

Replacement
1. Install the Front / Rear Cable Assembly (Figure 2).
2
Wrap the cable around the pulley
five times. Make sure the sphere in
the middle of the cable is positioned
in the groove in the pulley
Figure 2 Routing the Cable Assembly
Verify that the cable is not twisted and that the Cable Assembly is not contacting any surround-
ing components or wires.
2. Reinstall the Full-rate Carriage (REP 6.21).
3. Move the Full-rate Carriage by hand to verify proper operation.
4. Perform a Full/Half-rate Carriage Parallel Adjustment (ADJ 6.2).
5. Reinstall the Rear Cover (REP 6.4).
6. Reinstall the Right Cover (REP 6.2).
7. Reinstall the Left Cover (REP 6.3).
8. Reinstall the Control Panel Assembly (REP 6.23).
9. Reinstall the Platen Glass (REP 6.1).
Initial Issue
Phaser 790/DocuColor 2006
1
3
Attach Spring to Insert the cable end into
the groove in the
the end of the
bracket and route the
cable
cable as shown
CAUTION

REP 6.18 Carriage Motor

Parts List on PL 16.4
Removal
To avoid personal injury or shock, do not perform repair activities with the power switch
on or electrical power applied to the machine.
1. Switch off the machine power and disconnect the machine Power Cord.
2. Remove the Carriage Motor (Figure 1).
3
Remove the screws (3) and
the Carriage Motor by moving
it in the direction indicated
Figure 1 Removing the Carriage Motor
Replacement
1. Perform the procedure for removal in reverse.
10/00
4-49
WARNING
2
Disconnect the
1
Spring
Disconnect the connector
Repairs and Adjustments
REP 6.17, REP 6.18