Rep 10.14 Exchange Solenoid; Rep 10.15 Cleaner Cam Solenoid - Xerox Phaser 790 Service Manual

REP 10.14 Exchange Solenoid

Parts List on PL 8.5
Removal
To avoid personal injury or shock, do not perform repair activities with the power switch
on or electrical power applied to the machine.
1. Switch off the machine power and disconnect the machine Power Cord.
2. Remove the Exit Tray Assembly (REP 8.30).
3. Remove the Fuser Assembly (REP 10.1).
4. Remove the Main Fuser Assembly (REP 10.2).
5. Remove the Exchange Chute (REP 10.13).
The Fuser Rear Rail and Fuser Tray Assembly are connected by a harness. Be careful not to
pull too far apart while disassembling the components.
The gear is no longer secured when the EXCHANGE BRACKET is removed. Be careful not to
allow the gear to fall out while disassembling the components.
6. Remove the Exchange Solenoid (Figure 1).
Replacement
1. Reinstall the Exchange Solenoid in the reverse order of removal.
1
4
Remove the
screws
Remove the
screws to remove
the Exchange
Solenoid Assem-
bly
2
Remove the
Fuser Rear Rail
3
together with
Disconnect the
the Gear Cover
connector
Figure 1 Removing the Exchange Solenoid
Initial Issue
Phaser 790/DocuColor 2006
WARNING
CAUTION
5
Remove the
screws to
remove the
Exchange
Solenoid

REP 10.15 Cleaner Cam Solenoid

Parts List on PL 8.7
Removal
To avoid personal injury or shock, do not perform repair activities with the power switch
on or electrical power applied to the machine.
1. Switch off the machine power and disconnect the machine Power Cord.
2. Remove the Exit Tray Assembly (REP 8.30).
3. Remove the Fuser Assembly (REP 10.1).
4. Remove the Main Fuser Assembly (REP 10.2).
The Fuser Rear Rail and Fuser Tray Assembly are connected by a harness. Be careful not to
pull too far apart while disassembling the components.
5. Remove the Cleaner Cam Solenoid (Figure 1).
5
Remove the screws to remove the
Cleaner Cam Solenoid
2
Remove the
Fuser Rear
Rail with the
Gear Cover
1
Remove the
screws
Figure 1 Removing the Cleaner Cam Solenoid
10/00
4-123
WARNING
CAUTION
4
Remove the screws.
Then, remove the Input
Bracket Assembly
3
Disconnect the
connector
Repairs and Adjustments
REP 10.14, REP 10.15