Rep 10.8 Front Fuser Exit Sensor; Rep 10.9 Rear Fuser Exit Sensor - Xerox Phaser 790 Service Manual

REP 10.8 Front Fuser Exit Sensor

Parts List on PL 8.2
Removal
To avoid personal injury or shock, do not perform repair activities with the power switch
on or electrical power applied to the machine.
1. Switch off the machine power and disconnect the machine Power Cord.
2. Remove the Main Fuser Assembly (REP 10.2).
3. Remove the Upper Guide Assembly (REP 10.3).
4. Remove the Lower Guide Assembly (REP 10.7).
5. Remove the Front Fuser Exit Sensor (Figure 1).
Replacement
1. Reinstall the Front Fuser Exit Sensor in the reverse order of removal.
1
Disconnect the
connector
2
Unhook the sensor from the
Bottom Plate and remove the
Front Fuser Exit Sensor
Figure 1 Removing the Front Fuser Exit Sensor
Repairs and Adjustments
REP 10.8, REP 10.9
WARNING

REP 10.9 Rear Fuser Exit Sensor

Parts List on PL 8.2
Removal
To avoid personal injury or shock, do not perform repair activities with the power switch
on or electrical power applied to the machine.
1. Switch off the machine power and disconnect the machine Power Cord.
2. Remove the Main Fuser Assembly (REP 10.2).
3. Remove the Upper Guide Assembly (REP 10.3).
4. Remove the Lower Guide Assembly (REP 10.7).
5. Remove the Rear Fuser Exit Sensor (Figure 1).
Replacement
1. Reinstall the Rear Fuser Exit Sensor in the reverse order of removal.
1
Disconnect the
connector
Figure 1 Removing the Rear Fuser Exit Sensor
10/00
4-118
WARNING
2
Unhook the sensor
from the Bottom
Plate and remove
the Rear Fuser Exit
Sensor
Phaser 790/DocuColor 2006
Initial Issue