Rep 9.5 Locating Rail - Xerox Phaser 790 Service Manual

REP 9.5 Locating Rail

Parts List on PL 5.1
Removal
To avoid personal injury or shock, do not perform repair activities with the power switch
on or electrical power applied to the machine.
1. Switch off the machine power and disconnect the machine Power Cord.
2. Remove the Top Cover Assembly (REP 14.4).
3. Remove the Copy/Print Cartridge (REP 9.1).
4. Remove the ROS (REP 9.3).
5. Prepare to remove the Locating Rail (Figure 1).
3
Disengage the harness
from the clamps
Figure 1 Preparing to Remove the Locating Rail
Be careful not to touch IBT Belt, or damage the harnesses or Magnetic Roll surface of the
Developer Housing while removing the Locating Rail.
6. Remove the Locating Rail (Figure 2).
Initial Issue
Phaser 790/DocuColor 2006
WARNING
1
Disconnect the connectors
2
Disengage the harness
from the clamps
CAUTION
Replacement
Be careful not to touch IBT Belt, or damage the harnesses or Magnetic Roll surface of the
Developer Housing while reinstalling the Locating Rail.
1. Reinstall the Locating Rail in the reverse order of removal.
1
Loosen the rear
screws
2
Remove the front
screws
Figure 2 Removing the Locating Rail
10/00
4-95
CAUTION
3
Remove the Locating Rail
through the front
Repairs and Adjustments
REP 9.5