Rep 7.3 No Paper Sensor Assembly; Rep 7.4 No Paper Sensor - Xerox Phaser 790 Service Manual

REP 7.3 No Paper Sensor Assembly

Parts List on PL 3.1
Removal
To avoid personal injury or shock, do not perform repair activities with the power switch
on or electrical power applied to the machine.
1. Switch off the machine power and disconnect the machine Power Cord.
2. Remove the Tray 1 Assembly. (REP 7.6)
3. Remove the Front Mid Cover (REP 14.2) or the Duplex Tray Assembly (REP 8.27).
4. Remove the Sensor Bracket. (REP 7.2)
5. Remove the No Paper Sensor Assembly. (Figure 1)
Figure 1 Removing the No Paper Sensor Assembly
Replacement
1. Perform the procedure for removal in reverse.
Repairs and Adjustments
REP 7.3, REP 7.4
WARNING
1
Unhook the No Paper
Sensor Assembly from the
Sensor Bracket and
remove the assembly

REP 7.4 No Paper Sensor

Parts List on PL 3.1
Removal
To avoid personal injury or shock, do not perform repair activities with the power switch
on or electrical power applied to the machine.
1. Switch off the machine power and disconnect the machine Power Cord.
2. Remove the Tray 1 Assembly. (REP 7.6)
3. Remove the Front Mid Cover (REP 14.2) or the Duplex Tray Assembly (REP 8.27).
4. Remove the Sensor Bracket. (REP 7.2)
5. Remove the No Paper Sensor Assembly. (REP 7.3)
6. Remove the No Paper Sensor. (Figure 1)
1
Release the
locking tabs and
remove the No
Paper Sensor
from the Sensor
Bracket
Figure 1 Removing the No Paper Sensor
Replacement
1. Perform the procedure for removal in reverse.
NOTE: When installing the No Paper Actuator, the Actuator must be positioned directly above
the No Paper Sensor.
10/00
4-54
WARNING
2
Disconnect the
connector
Phaser 790/DocuColor 2006
Initial Issue