Rep 1.8 Environment Sensor - Xerox Phaser 790 Service Manual

REP 1.8 Environment Sensor

Parts List on PL 11.2
Removal
To avoid personal injury or shock, do not perform repair activities with the power switch
on or electrical power applied to the machine.
1. Switch off the machine power and disconnect the machine Power Cord.
2. Remove the Bypass Tray / Registration Assembly (REP 8.10).
Be careful not to touch the IBT Belt surface while removing the Environment Sensor.
3. Remove the Environment Sensor (Figure 1).
Replacement
NOTE: The screw that secures the Environment Sensor also secures the ground wire.
1. Reinstall the Environment Sensor in the reverse order of removal.
2
Compress the
standoffs
3
Remove the
Environment
Sensor
Figure 1 Removing the Environment Sensor
Initial Issue
Phaser 790/DocuColor 2006
WARNING
CAUTION
1
Disconnect the
connector
10/00
4-9
Repairs and Adjustments
REP 1.8