Rep 5.10 Adf Exit Sensor And Exit Tray Interlock - Xerox Phaser 790 Service Manual

REP 5.10 ADF Exit Sensor and Exit Tray Interlock

Parts List on PL 17.7
Removal
To avoid personal injury or shock, do not perform repair activities with the power switch
on or electrical power applied to the machine.
1. Switch off the machine power and disconnect the machine Power Cord.
2. Remove the ADF Front Cover and Rear Cover.
3. Remove the Outer Exit Chute Assembly. (Figure 1)
2
Remove the Outer Exit Chute
Assembly by moving the assembly
in the direction indicated
Figure 1 Removing the Outer Exit Chute Assembly
Repairs and Adjustments
REP 5.10
WARNING
1
Remove four
screws
retaining the
Outer Exit
Chute
Assembly
4. Remove the Exit Chute. (Figure 2)
1
Loosen the two retaining
screws
Figure 2 Removing the Exit Chute
10/00
4-34
2
Remove the
Exit Chute by
moving it in the
direction indi-
cated
Initial Issue
Phaser 790/DocuColor 2006